• Complimentary shipping on orders above $800. Prices are inclusive of GST*
UniFi UA-G2 (Protect Access Reader 2nd Gen. NFC Card reader)

    UniFi UA-G2 (Protect Access Reader 2nd Gen. NFC Card reader)

    Tax included. Shipping calculated at checkout.
    Compact, second-generation NFC card reader and request-to-exit device that supports hand-wave door unlocking.

    Unlock using an NFC card or UniFi Identity mobile app

    Additional handwave unlock functionality

    Entry and exit greeting messages

    Connects to UniFi Access Hub using PoE

    IP55 weather resistance (-30 to 45° C)


    Access G2 Reader

    Access G2 Reader


    Technical Specifications

    Dimensions 93 x 40 x 36.5 mm (3.7 x 1.6 x 1.4")
    Weight 82 g (2.9 oz)
    Enclosure material Polycarbonate, glass
    Mounting In wall, gang box
    Weatherproofing IP55
    Networking interface (1) 10/100 MbE RJ45 port
    Connectivity BLE 4.1
    Power method PoE
    UL 294 Power-limited Class 2 PSU
    UL 60950-1/62368-1 LPS/PS2 PSU
    Supported voltage range 48V DC
    Max. power consumption 5W
    ESD/EMP protection Air: ±15kV, contact: ±8kV
    Sensors Proximity sensor
    Speaker (1) 8 ohm, 0.7W
    LEDs R/G/B/W
    Button (1) Factory-reset
    NFC frequency 13.56 MHz
    NFC read range < 30 mm
    NFC standards ISO 14443A, 14443B, 15693
    NFC technology NFC Tag 1,2,3,4,5
    MIFARE Classic
    MIFARE Ultralight
    Operating environment Outdoor use
    Ambient operating temperature -30 to 45° C (-22 to 113° F)
    Ambient operating humidity 5 to 90% noncondensing
    Software information The software version of a product can be checked at https://unifi.ui.com
    UL 294 level Destructive attack: Level I
    Line security: Level I
    Endurance: Level I
    Standby power: Level I
    UL 294 statement Compliance with IEEE 802.3 specifications was not verified as part of UL 294.
    The equipment is intended to comply with the section of the National Electrical Code, ANSI/NFPA 70, Article 725.121, Power Sources for Class 2 and Class 3 Circuits.
    PoE cabling requirements Cable 5e cabling is the minimum performance category recommended. The performance category utilized should match the transmission speed required at the installation site.
    The minimal conductor gauge permitted to connect between the PSE or power injector and the PD shall be 26 AWG (0.13 mm2) for patch cords; 24 AWG (0.21 mm2) for horizontal or riser cable.
    CAN/ULC-60839-11-1 Grade Grade assignment: I
    Certifications CE, FCC, IC, UL 294, CAN/ULC-60839-11-1
    Document number, and issue date and/or revision level UA-G2/UA-G2-Black, V02
    System Steady blue: Adopted/device is ready
    Steady white: Pending adoption
    Blinking white/blue: Upgrading firmware
    Strobing red: Emergency lockdown
    Management application UniFi Access: Version 1.5.9 and later